[Netkit.users] mpls problems

[Massimo Rimondini]

Dear Silvia,

I can run the very same command successfully, provided that a network
interface with an address on the same subnet as 10.0.1.2's exists.
Maybe you forgot to configure that interface?

P.S. The first command does not seem to be of much use: essentially, it
says that 10.0.1.2 is reachable through the gateway 10.0.1.2. Are you
sure this is what you meant?

Regards,
Massimo.


silvia.filippi a tele2.it wrote:
> Dear All,
>
> I'm trying to set up a laboratory to study mpls protocol.
> When I try to set the LSP giving commands like these:
>
>  ip route add 10.0.1.2/32 via 10.0.1.2 mpls 0x2
>
> or
>
> ip route add 10.0.5.0/24 via 10.0.1.2 mpls 0x3
>
> I receive the msg :" RTNETLINK answers: No such process ".
>
> Could someone help me in understanding what's going wrong?
>
> Thanks a lot
> Silvia Filippi
>
>
>
>
>
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Netkit.users mailing list
> Netkit.users a list.dia.uniroma3.it
> http://list.dia.uniroma3.it/mailman/listinfo/netkit.users
>   
-------------- parte successiva --------------
Un allegato HTML � stato rimosso...
URL: http://list.dia.uniroma3.it/pipermail/netkit.users/attachments/20091014/5155a8ab/attachment.htm