[Netkit.users] network interface startup
Massimo Rimondini
rimondin at dia.uniroma3.it
Wed May 19 14:54:30 CEST 2010
Hello Silvia,
could you please post the relevant section of your lab.conf?
Or try using "ifconfig -a" inside the affected VM?
I can successfully start a virtual machine with 5 interfaces using the
following lab.conf:
> pc1[0]=A
> pc1[1]=B
> pc1[2]=C
> pc1[3]=D
> pc1[4]=E
Cheers,
Massimo.
silvia filippi wrote:
> Hello,
>
> I've a problem in configuring network interfaces in lab.conf, because,
> also if I configure some network interfaces (more than 4) for a
> virtual machine, when it comes up I don't succeed to see more than 4
> interfaces using ifconfig command.
> The virtual hubs (file.cnct) are anyway created.
>
> Thanks for your suggestions
>
> Regards
> Silvia Filippi
>
>
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Netkit.users mailing list
> Netkit.users a list.dia.uniroma3.it
> http://list.dia.uniroma3.it/mailman/listinfo/netkit.users
>
-------------- parte successiva --------------
Un allegato HTML � stato rimosso...
URL: http://list.dia.uniroma3.it/pipermail/netkit.users/attachments/20100519/e238caa0/attachment.htm
More information about the Netkit.users
mailing list